| LPC1114 Kit |
The LPC1114 Starter Kit integrates the NXP LPC1114FBD48 processor which is used high-performance ARM Cortex-M0 32bit RISC kernel, works at up to 50MHz and belongs to the LPC1100 Series Microcontrollers. The LPC1100 Series works in the temperature range from minus 65 Celsius degrees to 150 Celsius degrees, and its power voltage is from 2.0V to 3.6V. The various power saving modes highlight its low power consumption feature. The comprehensive peripherals of the LPC1114 processor make it suitable for a variety of applications:
- Motor driver and application control
- PC peripherals
- Alarm system
|
| |
| Block Diagram of LPC1114 Kit |
 |
| |
| USB JTAG Debugger Features |
- Only support LPC1100 Series currently(Can support other Cortex-M0/M3 MCU later)
- Support SW/JTAG debug and Download
- Download speed up to 110Kb/s
- flexible debugging socket, support 20/10/8 pins connector
- Support Keil MDK and CooCox full series software
* Debugging conditions: use SW debug, the LPC1114 need to run at 50MHz frequency.
|
| |
| USB JTAG Debugger Features |
- LPC1114 32bit RISC processor, based on ARM Cortex-M0, 50MHz
- Eight LEDS
- One Power Indicator
- One BOOT Key-press
- One RESET Key-press
- 48pins IO extension One UART, supporting RS-485/EIA-485
- SSP Interface
- I2C Interface
- Eight Channels 10bits ADC Module
- One 10pins SWD Debugging Interface
- One temperature sensor
|
| |
| LPC1114 Target Board Software Resources |
Examples | Descriptions | Blinky | LED1 blinks | GPIO | GPIO interface interrupt trigger | PMU | Power management unit (PMU) sleep and deep sleep mode | SysTick | Implement the LED blink through the system time delay | Timer32 | Implement the LED blink through 32bits timer delay | WDT | Watchdog timer application example | SSP | SSP Synchronous Serial Communication | UART | UART interface send/accept character | I2C_EEPROM | I2C main mode to EEPROM read/write test | Temperature Sensor | Read the data of Temperature Sensor through I2C |
|
| |
| LPC1114 Starter Kit Standard Configuration |
- 1 x LPC1114LK Development Board
- 1 x UART DB9 to DIP cable
- 1 x MINI USB Cable
- 1 x Serial Port Cable
- 1 x CD-ROM
|
